T3-DO is a Mini Droid from Mr. Baddeley.
It’s a super easy print and build remote controlled droid.
Features:
- Simple Build
- Fast Print
- Needs only cheap basic electronics
- Super easy wiring
Recommended Print Settings:
- NO support needed
- 0.2mm layer height
- 3 outer walls (1.2mm)
- ~15% infill
Needed electronic components:
- 2x FS90R Servo
- 1x MG90 Servo
- 4.8v 1200mAH battery pack
- 6 channel (only 3 needed) RC controller/receiver (Needs Tank Mix!)
Instructions with more information is are attached below.
For more information check out the Mr. Baddeley Group and the files are available in Mr. Baddeleys Patreon