MS-MM1

Estimated reading time: < 1 min

MS-MM1 is a Mini Droid from Mr. Baddeley.
It’s a super easy print and build remote controlled droid.

Features:

  • Simple Build
  • Fast Print
  • Needs only cheap basic electronics
  • Super easy wiring

Recommended Print Settings:

  • NO support needed
  • 0.2mm layer height
  • 3 outer walls (1.2mm)
  • ~15% infill

Needed electronic components:

  • 3x FS90R Servo
  • 4.8v 1200mAH battery pack
  • 6 channel (only 3 needed) RC controller/receiver (Needs Tank Mix!)

Instructions with more information is are attached below.

For more information check out the Mr. Baddeley Group and the files are available in Mr. Baddeleys Patreon

Tags:
Was this article helpful?
Dislike 0 0 of 0 found this article helpful.
Views: 666
Previous: Wall-E (41%)