Estimated reading time: < 1 min

BD-1 is a Droid from Mr. Baddeley.
BD-1 is a super easy print and build for a static but animated droid.


  • Tilting and moving body, head and antennas
  • moving eye
  • Led Panel (optinal)
  • Sound

Recommended Print Settings:

  • NO support needed
  • 0.2mm layer height
  • infill varies depending on the part

Needed electronic components:

  • Arduino Mega2560
  • various servos
  • some screws, bolts, bearings
  • DF player, Speakers
  • Amplifier
  • 1x 7.2v 2200mAH battery pack

Instructions with more information are attached below.
And here:

For more information check out the Mr. Baddeley Group and the files are available in Mr. Baddeleys Patreon

Was this article helpful?
Dislike 0 5 of 5 found this article helpful.
Views: 5304
Previous: BD-1 Video Instructions
Next: BD-1 Control System