Mini CH-33P

Estimated reading time: < 1 min

Mini CH-33P is a Mini Droid from Matt Zwarts.
It’s a super easy print and build remote controlled droid.


  • Simple Build
  • Fast Print
  • Needs only few electronics
  • Rotating Dome

Recommended Print Settings:

  • See detailed print settings in the instructions
  • 0.2mm layer height
  • 3 outer walls (1.2mm)
  • ~10-30% infill

Needed electronic components:

  • 1x HC-05 Bluetooth module
  • 1x Arduino Nano
  • 2x MX1508 Motor driver boards
  • 3x DC 3V-6V DC 1:120 Gear Motor
  • 7.4V Lipo ~800mAh

Instructions with more information is are attached below.

For more information check out the Mr. Baddeley Group and the files are available in Mr. Baddeleys Patreon

Was this article helpful?
Dislike 0 1 of 1 found this article helpful.
Views: 428