K1-TT

Estimated reading time: < 1 min

K1-TT is a Mini Droid from Mr. Baddeley.
It’s a super easy print and build remote controlled droid.

Features:

  • Simple Build
  • Fast Print
  • Needs only cheap basic electronics
  • Super easy wiring
  • Track based
  • Lights

Recommended Print Settings:

  • NO support needed
  • 0.2mm layer height
  • 3 outer walls (1.2mm)
  • ~15% infill

Needed electronic components:

  • 2x Pololu HP 20.4:1 25mm motors
  • Small 5-10A dual Motor driver
  • Arduino + Leds for additional “KITT” Light
  • 6 channel (only 3 needed) RC controller/receiver (Needs Tank Mix!)

Instructions with more information is are attached below.

For more information check out the Mr. Baddeley Group and the files are available in Mr. Baddeleys Patreon

Tags:
Was this article helpful?
Dislike 0 0 of 0 found this article helpful.
Views: 722
Previous: EY-3B (Rover EyeBot)
Next: BB-R2